Thought I would send you some pics of custom 4 inch Cenobites I made after having a Halloween challenge put to me at a custom figure website. They are made from a mix of GI Joe, PTE and Star Wars figures.
The recipes for the figures are:
Pinhead
- Head: Star Wars Lobot, all holes drilled with 0.15mm drill bit and filled with 0.1mm jewellers wire
- Torso/Arms: GI Joe Sand Scorpion
- Skirt: Star Wars Ep. III Tion Medon
Female
- Head: ST: Motion Picture Ilia with wire inserted
- Torso/Arms: GI Joe VvV Scarlett
- Skirt: modelling clay
- Knives: R/hand - GI Joe swamp rat, L/Hand - milliput
Butterball
- Head: Sculpted
- Torso/Arms: GI Joe Hard Drive
- Skirt: modelling clay
- Instruments: various
Chatterer
- Whole figure: PTE diver
- Head: Sculpted
Dio
Styrene sheets with printed background. Chains are hanging from ceiling piece.
Pillar of Souls: wooden block with picture of pillar glued on. The chains are thin ones I got from a hardware store and cut to length. I then put a ceiling piece on the background piece I use for other figures and drooped the chain through them. I deliberately left the top piece off the photo to give the impression that the chains are just hanging in mid air.
